Radon is a naturally occurring radioactive gas that forms as uranium breaks down in rock and soil. In Missouri, where bedrock varies from county to county, some groundwater can carry dissolved radon. Because radon is a gas, it tends to escape when water is agitated, such as at a faucet, in a shower, or during a load of laundry. This guide explains what a Missouri well owner can check, how sampling works in general terms, and what to keep on file. It is an independent reference, not a laboratory report, and it does not tell you what any result means for your household.
Why radon is tested separately
Most routine well panels look at bacteria, nitrate, metals, and hardness. Radon is measured on its own. A standard sediment filter does not remove it, and a typical water softener is not designed to address it. Radon has no color, taste, or smell, so a clear, odorless sample tells you nothing about whether radon is present.
What you can check at home first
- Note the well depth and the geologic formation listed on the drilling record, if you have one.
- Ask whether neighbors on nearby wells have ever reported radon results, and keep those notes separate from your own data.
- List every fixture that draws well water, including showers, laundry, dishwashers, and any humidifier.
- Locate the point of entry, usually near the pressure tank or where the supply line enters the house.
How sampling generally works
Radon samples are collected differently from bacteria samples. Water is usually drawn into a sealed container with little or no air space so that gas does not escape before analysis. Sampling instructions come from the testing program or laboratory you choose, and you should follow them exactly. Ask whether the sample must be taken from a cold-water tap before any treatment equipment, whether the container should be filled slowly to limit bubbling, and how the container should be kept during transport.
Questions to ask before you collect a sample
- Does the program report radon in water and radon in indoor air as separate results?
- How long can the sample wait before it reaches the analysis step?
- Will the report list the sampling date, time, and tap location?
- Are containers supplied with the kit, and what storage conditions are required?
Reading the result without guessing
A report may list radon in water with a unit and a reporting limit. Keep the full report with your well records. A later result can differ when the well pumps differently, when a pressure tank is replaced, or when water levels shift after heavy rain. Repeat sampling only when the testing program recommends it. Do not compare your result with a neighbor's without considering depth, formation, and sampling method.
Air follow-up is a different test
Radon released from water can add to indoor air, but a water test does not measure indoor air. If you are concerned about air, a separate indoor air test is the usual next step. Missouri homeowners can ask their local public health office or a state radon information service which kind of test fits their home. Keep water and air results in separate sections of your file so units and sampling conditions are never mixed.
Keeping your file
Store each report with the sampling date, the tap used, the well depth, and any treatment equipment present at the time. If you change equipment or repair the well, add a dated note. A labeled folder or a simple spreadsheet is enough. The goal is a record that a future owner, technician, or testing program can read without guessing what was done.
Limits of this guide
This page does not diagnose, reassure, or warn about any illness, and it does not state what level of radon is acceptable in your water. Those decisions belong with qualified professionals and with the program that issued your report. Use this guide to organize questions and records, then take the sample according to the instructions you receive.