A private well depends on electricity. In many Missouri homes the well pump runs from a dedicated breaker in the main service panel, and that breaker often sits near breakers for the furnace, water heater, or a detached shop. When the water stops, the first question is usually which breaker to check. A clear label answers that question quickly, and it prevents guesswork during a storm, a late-night outage, or a service call.

This guide covers what a homeowner can record and look for from the outside of the panel and the pump area. It does not replace a licensed electrician. Work inside the panel, the pressure switch wiring, and the pump control box should be left to a qualified person who can confirm the circuit is de-energized before touching anything.

Gather the Records First

Before opening any cover, collect what already exists. Look for the original well contractor's paperwork, the drilling or completion record, and any pump installation sheet. These papers often list the pump model, the voltage it was designed for, and the breaker size specified for the circuit. Treat these documents as reference only. Confirm every detail against the equipment in front of you, because repairs and upgrades over the years may have changed the setup.

Map the Pump Circuit Safely

A homeowner can make a useful first record without touching live parts:

  1. Photograph the full panel door and the inside labels, then write down any breaker names that look wrong, faded, or missing.
  2. Note which breakers are double-pole, since pumps commonly use a two-pole breaker, and check whether any neighboring breaker shares the same wire routing.
  3. Trace the wires from the pump control box back toward the panel, but do not disconnect or reroute anything yourself.
  4. Ask the electrician to confirm the pump breaker with a proper tester, then write the result on a card inside the panel door.

If a breaker trips often, or if the panel shows burn marks, a warm smell, or loose connections, stop and call a qualified electrician. Those signs point to a problem that a label alone will not fix.

Write a Clear Panel Label

A useful label names the function, not just the location. Instead of writing only well, write well pump, control box at pump house, or well pump, two-pole, do not switch off during water use. Use a permanent marker or a printed label, and keep it legible. If the panel has no directory, add a simple card that lists each breaker number with its circuit name, and date the card when it is updated.

Keep a Simple Power Record

Add a short entry to your well file each time something changes. Record the date, the breaker involved, what was done, and who did it. Include any outage that affected the pump, along with the time power returned. Over the years, this record helps a new owner, a service provider, or an electrician understand the system without starting from zero.

Plan for Outages

Missouri storms can cut power to rural homes for long periods. Know where the pump breaker is before a storm arrives. If you use a generator, confirm with a qualified electrician how it connects to the home, and never backfeed the panel through an ordinary extension cord. A labeled panel and a written record make that conversation faster and safer.

Reference Notes

This guide is an independent homeowner reference for Missouri private wells. It describes records and checks a homeowner can make safely. For wiring, testing, or repairs inside the panel or pump system, rely on a licensed electrician and the manufacturer's instructions for your specific equipment.